routing

  1. D

    Routing hickory......?

    Hey, I'm routing some hickory stingers for a housed and wedged stair. I've routed half a stringer and blown apart 2 BRAND NEW router bits. Any ideas?
  2. Sight-base blank prepped for profiling

    Sight-base blank prepped for profiling

    This rosewood blank has been drilled through the waste area and the slot has been cut; saw cuts will be made tangent to the holes to remove the waste before profiling on the router table. The pivot bushings have been installed
    • johnpipe108
    • Media item
    • preparation routing shaping
    • Comments: 0
    • Album: A Rosewood Rifle Sight
  3. Wine Cellar WIP

    Wine Cellar WIP

    Pattern following bit for Bottle Shelf
    • McRabbet
    • Media item
    • cellar routing wine
    • Comments: 0
    • Album: Wine Cellar
  4. Wine Cellar WIP

    Wine Cellar WIP

    Bottle Shelf after routing pocket, pattern routing perimeter and rounding over edges.
    • McRabbet
    • Media item
    • cellar routing wine
    • Comments: 0
    • Album: Wine Cellar
  5. Wine Cellar WIP - Routing 2

    Wine Cellar WIP - Routing 2

    Roundovers complete - 2 groups have different hole space for screw clearance. Short partition with 1/8" deep dados shown
    • McRabbet
    • Media item
    • project routing wine
    • Comments: 0
    • Album: Wine Cellar
  6. M

    routing routine

    I would appreciate advice on a trivet project i have in mind. I plan to make a large number of these: The plan is to use solid cherry squares. sau 10" by 10", and 3/4" thick. on the top side, I'd like to cut a square form, 8" by 8" and down into the wood 1/4" deep. Into the square cut out...
  7. Vanilla Gorilla

    Pattern routing

    I need some tips on routing to a pattern. Or more specifically, creating the pattern to rout to. I am wanting to make an arched apron for the coffee table I am working on, and I am having a difficult time of making the pattern with symmetrical curves. I used a grid and plutted out points and...
  8. M

    Need Advice for Routing Raied Door Panels

    I am looking for some advice on routing raised panels. I just picked up my first raised panel bit and I have to admit, I am a little intimidated after trying a piece of scrap. I routed across the end of a board and it did not feel safe. I then tried to make several passes raising the bit a...
  9. DaveO

    Router plate recess routing

    I got the JessEm router plate for my RT under construction. The instructions say to use a either a 1-1/2" dia pattern bit or a 1/2" dia straight bit with a 3/4" template guide to route the recess to obtain the 3/4" corner radius . I have neither and really don't want to buy either. What I am...
  10. DaveO

    Free hand routing w/ straight edge

    When routing a daddo with a single straight edge like a Clamp-n-guide, what is the best side to run the router on. I would think that the router would have the tendency to pull to one side, and that would be the side to have the guide on. Dave:-)

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top