I am trying to figure out how to match some trim for a piece I'm working on. I need 25' of OAK 3/4 X 1 1/2 with a 3/4" bull nose type curve on each side. I could just use a bull nose router bit, but it would leave a flat spot between curves. I could also cut a bull nose on each piece, rip it to dimension, sand it down and glue everything up, probably with biscuits. That would be approx. 50 ' plus more time than I want to put into the trim.
Sorry about the picture quality, but this is what I'm trying for.
http://www.ncwoodworker.net/pp/data/321/medium/molding_001.JPG
Thanks for any suggestions!
Sorry about the picture quality, but this is what I'm trying for.
http://www.ncwoodworker.net/pp/data/321/medium/molding_001.JPG
Thanks for any suggestions!