motor

  1. smessick

    Bandsaw Motor Speed

    I am replacing the motor on my Powermatic 14" bandsaw with a bigger HP motor for resawing. The original motor is 1750 RPM.The bigger motor I have is 3450 RPM. I am using a motor pulley half the size of the original to maintain the same surface speed. I did the same thing with a combination...
  2. Arguseyed

    Contractor saw - motor removal

    This might be a stupid question but since I know less about electricity than I do brain surgery, I though I'd ask here. Is there any reason I could / should not install a quick disconnect in the wire that runs from the motor on my contractor's saw to the switch? In anticipation of rolling my...
  3. ashley_phil

    Free CRAFTSMAN Table Saw needs Motor - CLT

    Merry Christmas to someone! Craftsman 10 inch table saw
  4. woodworker2000

    Raleigh CL - Free Rockwell Delta RAS motor needs rewinding

    Found this on CL (not mine) and thought someone might be interested. Saw is located in Morrisville (near RDU for those not familiar with Raleigh). There are pics in the CL ad: http://raleigh.craigslist.org/tls/207257953.html Ad: I have an industrial Rockwell/Delta radial arm saw. I used it...
  5. H

    Delta Contractors saw motor problem

    Any diagnosis or repair hints for me? My Delta Contractors saw motor is no longer working after I stalled the motor and tripped the breaker. It restarted one time when I reset the breaker, but now the motor only hums and does not turn. I thought the problem might be the start capacitor...
  6. S

    need cheap low speed motor

    .
  7. D L Ames

    Looking for 1/3 hp motor

    I am looking for an inexpensive 1/3 hp motor, 1/2 or 5/8" shaft, with about 1725 RPM to use with a buffing wheel. Does anyone now of a decent source for a motor like this? I see HF has on that might fit the bill. The motor will not see any heavy use and will only be used occasionally. TIA, D L
  8. Steve D

    Suggestions for spare motor??

    I thought I'd put the collective genius to work here and see what you come up with. I have a new 1/2 hp 120V 1725 RPM 1/2" shaft motor that I bought off Ebay a while back that has just been gathering dust. I had initially planned to use it for a fan but Northern tool had a sale on a complete...
  9. chris99z71

    Radial arm saw motor

    So I had my friend who works at a motor shop check on the cost of converting to the optional 3hp, single phase 220V motor for my "new" radial arm saw to avoid the 3 phase issue. His cost with discounts is $1500!!! On a saw that retails for $3k. Oh well... I guess I'm either going to have to...
  10. L

    Router Motor Speeds

    Is there an article or chart that shows the best router motor speeds for doing various jobs in various types of woods? If so, can someone point me to it, please? Larry :-?

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top