mistake

  1. T

    just ordered some new blades hope I did not make a mistake

    just bought ordered some saw blades hope I did not make a bad choice Oshlun 10" 80T Hi-ATB Laminate, Melamine & Plywood Blade 5/8" Arbor Oshlun 10" 24T ATB Ripping Blade 5/8" Arbor Oshlun 10" 50T ATB+R Combination Blade 5/8" Arbor I wanted the 80T hi ATB blade that is what started...
  2. Tom Dunn

    Big mistake

    was working on a cherry Hope Chest, same one I've messed with now for some time. The top is 3/4 stock, about 18x36 or so. The top is comprised of two pieces, the rear section, that fastens to the carcass is about 3" wide, and the wider piece of the top is hinged to it. The edges of the top...
  3. DaveO

    I may have made a big mistake....

    I made my wife some noggin' knockers :eek::swoon::swoon: Over the Holiday the LOML (the most beautiful, sweet, and smart AudreyO) did a bit of carving with her Dad. She commented to me that it would be nice to have a mallet to help with the bulk chiseling. I must have had a bit too much...
  4. Rob

    Turning a mistake into something useful

    My first drawer using locking rabbit joints, turned out great, except for I mis-measured. Measured 22", had 24" on the brain. Didn't figure out until I actually put the drawer in. I just figured it was practice. This morning I was looking at it and had this idea. I do most of my finishing...
  5. T

    How to fix this mistake? w/ pics

    I was routing tonight and had to 96 chamfer cuts on tongue and grove slats with m router station. I missed on one and really tore in to piece. Giventhe location of the board it will not be visible on the project (bed foot board against the box spring. Never the less I want to repair it the best...
  6. Toddler

    Bet this is a mistake

    But I said I'd take it. $6250. What do you want to bet it's a mistake and they meant 26,250 :) Todd
  7. DaveO

    How do I fix this @#&*% mistake

    I have been making a table based on this design out of QSWO. This is how far I have got. My mistake was made when I cut out the drawer opening and got a little overzealous on it's height. I don't think that I left enough on the bottom of the apron to cut out the decorative detail on...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top