joint

  1. View Camera, 4x5

    View Camera, 4x5

    View Camera: view through the ground glass, inverted to right side up for convenience.
  2. View Camera, 4x5

    View Camera, 4x5

    View Camera: Conley anastigmat lens in Wollensak Optimo shutter (manufactured from 1910 to 1930).
  3. View Camera, 4x5

    View Camera, 4x5

    View Camera, spring tabs secure convertible back.
  4. View Camera, 4x5

    View Camera, 4x5

    View Camera
  5. View Camera, 4x5

    View Camera, 4x5

    View Camera
  6. View Camera, 4x5

    View Camera, 4x5

    View Camera
  7. 4x5 Camera

    4x5 Camera

    4x5 View Camera. Box joint, my first, done by router table with basic keyed miter fence technique.
  8. 4x5 Camera

    4x5 Camera

    4x5 View Camera. "Engineers Prototype" of back-end; to be done in re-vamped design, probably in walnut like the rear body.
  9. 4x5 Camera

    4x5 Camera

    4x5 View Camera. Re-cycled Calumet 26" bellows cut down (damaged rear-end)\' about 15" from front of lens-board to focal plane.
  10. 4x5 Camera

    4x5 Camera

    4x5 View Camera. Front standard mahogany? Front panel oak; lens board birch ply.
  11. Kitchen Light

    Kitchen Light

    Kitchen Light detail
  12. Kitchen Light

    Kitchen Light

    Kitchen Light On
  13. Kitchen Light

    Kitchen Light

    Kitchen Light Off
  14. Box Joint Jig

    Box Joint Jig

    Box joint jig
  15. Box Joint Jig

    Box Joint Jig

    Box joint
  16. Box Joint Jig

    Box Joint Jig

    Base, rear fence, rear sub-fence, front fence, runners
  17. Box Joint Jig

    Box Joint Jig

    Box joint jig base
  18. iBox Box Joint Jig

    iBox Box Joint Jig

  19. W

    New Box Joint Jig ???

    In the discussion linked below, some references are made of a new box joint jig that would be coming to market soon. Just wondering if there are any updates. http://www.ncwoodworker.net/forums/showthread.php?t=36052&highlight=box+joint I know there are lots of plans for making box joint...
  20. erasmussen

    box joint jig

    I finally got around to making a good box joint jig. Yes its a bit ugly but it works good. I used a 1/4 x 20tpi threaded rod, a captured ball bearing in one end and i threaded a block of UHMW for the other end so that I have 0 play in the screw assy. I checked it out with a couple of scrap...

Our Sponsors

LATEST FOR SALE LISTINGS

Top