Hi all, I need a bit of advice.
Now that I've broken the non-flat Ridgid granite top tablesaw (thank goodness for AmEx purchase protection), I'm ready to order a new, better table saw. I was ready to buy Grizzly's G0691. That is until I saw Grizzly's black friday ad. This puts the G0651 at a very similar price to the G0691. Now I just cannot decide which one to buy.:icon_scra:dontknow:
I only see a few main differences between the two: the G0651 has an outfeed table, a digital bevel idsplay, and a couple extra inches in its rip capacity; but the G0691 has about 20% greater arbor speed than the 651 (4300 RPM for the 691; 3600 RPM on the 651). I also cannot tell if there should be a difference in vibration due to the power transfer setup (triple V-belts for the 691 vs a flat - I assume poly-v - belt for the 951).
Any thoughts would be greatly appreciated. - I have such a terible time trying to make this sort of decision.
Thanks in advance,
David
Now that I've broken the non-flat Ridgid granite top tablesaw (thank goodness for AmEx purchase protection), I'm ready to order a new, better table saw. I was ready to buy Grizzly's G0691. That is until I saw Grizzly's black friday ad. This puts the G0651 at a very similar price to the G0691. Now I just cannot decide which one to buy.:icon_scra:dontknow:
I only see a few main differences between the two: the G0651 has an outfeed table, a digital bevel idsplay, and a couple extra inches in its rip capacity; but the G0691 has about 20% greater arbor speed than the 651 (4300 RPM for the 691; 3600 RPM on the 651). I also cannot tell if there should be a difference in vibration due to the power transfer setup (triple V-belts for the 691 vs a flat - I assume poly-v - belt for the 951).
Any thoughts would be greatly appreciated. - I have such a terible time trying to make this sort of decision.
Thanks in advance,
David