mounting
-
B
Newbie Here - Question About Hangers for Ledge Shelves I'm Building
Read through the archives and see where this issue raised but never fully answered. My shelves [painted solid poplar] will be 1.5" thick, 6.5" deep, and up to 102" long ... a maximum weight of 15 lbs each before another 15 lbs maximum will be displayed atop. The ideal hardware would be 1.25"...- Blackbeered
- Thread
- hangers keyhole mounting shelves
- Replies: 8
- Forum: General Woodworking
-
Mounting tankless water heater to a vinyl sided building
As discussed in this thread, we are going to put in a propane tankless hot water heater. Our house has vinyl siding and the heater we are getting is an outdoor unit. What is the best way to attach this tankless hot water heater to the outside wall of our vinyl sided house? Do I need to cut...- MarkE
- Thread
- building mounting sided stuff vinyl
- Replies: 22
- Forum: DIY- Home improvement
-
E
Mounting Panel to Slanted Wall
Look I know this barely fits into the category of a woodworking question, but most woodworkers frequently need to think of creative solutions to mounting things, and so if anyone has any thought on this, I would appreciate it - if the moderator feels it doesn't belong, my apologies, please...- ejensen
- Thread
- mounting panel slanted wall
- Replies: 3
- Forum: General Woodworking
-
Shop cabinets - plywood and mounting drawer slides
I want to build some shop cabinets. Nothing too complicated - face frame, drawers, doors. But, I do want them to last a while, and since it's MY shop, I want them to look good too! I'm going to need quite a bit of plywood. I have not been terribly impressed with the hardwood plywood here at...- Bas
- Thread
- cabinets drawer mounting plywood shop
- Replies: 23
- Forum: Workshop Discussion
-
Hinge/Door Mounting Tricks?
Hi all, I am about to mount doors to some wall cabinets I have been working on. The cabinets all have face frames with one large door on the left, with a middle stile and then two narrower doors on the right. I elected to go with overlay 3/8” inset hinges. One side of the hinge will attach to...- Canuck
- Thread
- hinge or door mounting tricks
- Replies: 6
- Forum: General Woodworking
-
J
Mounting outfeed table
Hello All Newbie here so be gentle. I am looking for different processes I can use to attach my 14" wide extension to my table saw.I am using a piece of melamine for my extension, I will wrap the melamine with oak before installing. I just want something to cover over the motor as it is a...- Jerry
- Thread
- mounting outfeed table
- Replies: 1
- Forum: Power Tools and Their Use
