Ok, wood AND metal workers. I purchased a toolrest and did not think about the post length. So far I have 1) welded an extension on with my stick welded - the weld broke :BangHead:,
2) welded the extension on with my wire welder – the weld broke :BangHead: :BangHead:,
3) cut a bevel and indents into both and tried JB Weld (twice) – both times I could break it by hand :BangHead::BangHead::BangHead:.
I thought the "third time" was suppose to be a charm.
The "joint" will always be inside the banjo holder so there is only downward pressure.
Any way to join cast iron and steel? Brazing rod?
Thanks,
Mike
2) welded the extension on with my wire welder – the weld broke :BangHead: :BangHead:,
3) cut a bevel and indents into both and tried JB Weld (twice) – both times I could break it by hand :BangHead::BangHead::BangHead:.
I thought the "third time" was suppose to be a charm.
The "joint" will always be inside the banjo holder so there is only downward pressure.
Any way to join cast iron and steel? Brazing rod?
Thanks,
Mike