I have just completed my workbench. The top is laminated Red Oak and Maple (that I piscked up a different saw mills as scrap). 3'X6" and 2 1/4" thick. It is on a cabinet I made out of Red Oak and Maple as well.
What finish should I use on the top surface? I used Tung oil for the cabinet and the top origionally but whe I was sharpening my steel, the dirty water stained the top. This makes me think that the Tung Oil did not seal well enough with the two coats I put on.
Suggestions appreciated.
John
What finish should I use on the top surface? I used Tung oil for the cabinet and the top origionally but whe I was sharpening my steel, the dirty water stained the top. This makes me think that the Tung Oil did not seal well enough with the two coats I put on.
Suggestions appreciated.
John