direction

  1. F

    Looking for some direction / suggestions on this project

    I've been asked to build this for someone. I'm sort of stuck on the general design at this point. The front panels are curved so it has to be a formed piece, and it has to be very load-bearing. I'm planning on the entire project being panels of vacuum pressed veneer work, but they aren't...
  2. BrianInChatham

    Feed direction relative to drum rotation in drum sander

    I picked up a used Grizzly 24" dual drum sander recently and finally got around to setting it up last night. Once I got the drums dialed in it produces a decent finish, but the stock is coming out with a thick layer of sawdust compressed to the surface. I've noticed when I brush it off that in...
  3. C

    need a little direction

    Manfre has added a post to an donation drive thread where he expressed interest in perusing the site's financials. I don't care and know we have nothing to hide, but here is where I'm falling short. I tried to see his level of use, is he a corporate member, and I don't know how to tell. I...
  4. D

    Want direction

    I need to sell a ShopSmith Mark V-510 that belonged to my late husband. Any suggestions?
  5. decibel

    Table top grain direction / end grain

    OK I'm FINALLY getting around to using some wood and building something. The table top I'm looking at creating a table top this about 53" X 34". So my question is while gluing up the table top I was going to use boards 53+ inches long but I'm that is difficult with the wood I have as I can't...
  6. M

    Headed in a new direction...

    Hey guys -- I guess most of you regulars who've read a post or two of mine know I'm not much more than a beginning woodworker. I've certainly been dabbling for a long time, but in the past couple months I'm trying to wean myself of power tools, but not completely (they ARE an asset). The...
  7. W

    Possible to Rervese the Rotational Direction of a Single Phase Electric Motor?

    Is it possible to reverse the rotational direction of a single phase electric motor? I know this can be done easiely with 3 phase motor by switching a pair of wires. But how about a single phase AC motor? Ideas are greatly appreciated:wsmile:. Qui
  8. cskipper

    What direction should the grain go?

    When cutting a cross out of 1/8th or 1/4" hardwood, what direction should the grain run? If it runs in the direction of the "arms" then length of the cross is at risk of breaking along the grain and visa versa. I do not want to piece together the wood first to allow for the grain change.
  9. F

    Need a push in the right direction

    I want to make some sort of yard decoration for my gf and her kids. should i go buy a template, or just get an idea and cut it out. I took some pictures of my workshop. i will try and attach them or make a gallery

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top