I need to sharpen my router plane. I flattened the sole of the p-lane and the bottom of the blede on my worksharp. I then sharpened freehand as the blade is too short to fit into the worksharp and will not work in the wide blade attachment. I also could not figure out how to sharpen it using a standard guide and diamond stone but again because of the short blade it does not work.
Freehand on the worksharp worked OK but I had a little tear out. I am working with tiger maple and it was difficult on the jointer as well but I know my jointer is slightly dull (just afraid to change the blades as it is so hard to realign).
Does anyone have a suggestion for a jig etc. to sharpen these type blades?
Freehand on the worksharp worked OK but I had a little tear out. I am working with tiger maple and it was difficult on the jointer as well but I know my jointer is slightly dull (just afraid to change the blades as it is so hard to realign).
Does anyone have a suggestion for a jig etc. to sharpen these type blades?