A few months back I posted a question about drying fresh cut pine I got from Randy (woodbutcher). I took the stack/sticker/ratchet strap and spray with Timbor (Borate insect treatment) advice. It was ~12% moisture level the last time I checked it. The lumber is full 2" X 4" and 2" X 6" and dryed very straight. Almost didn't want to use some of the sticks as they were quartersawn and had no knots! Amid rain, thunder, tornado warnings, hail, high winds and a trip to Kyle's here's what I've accomplished since Thursday evening:
This 5.5 X 12 ft expansion will house my wood collection and eventually house my cyclone and compressor when I move the woodshop out of the garage.
Here's what happens when you push the back of a Hitachi gas powered nail gun inside of a 16" stud cavity with your left hand and fire it...ouch:
Will be siding, hanging rafters, purlins and putting on an Ondura corrugated roof when I get back from Denvernashvegas.
This 5.5 X 12 ft expansion will house my wood collection and eventually house my cyclone and compressor when I move the woodshop out of the garage.
Here's what happens when you push the back of a Hitachi gas powered nail gun inside of a 16" stud cavity with your left hand and fire it...ouch:
Will be siding, hanging rafters, purlins and putting on an Ondura corrugated roof when I get back from Denvernashvegas.