expansion

  1. IMG-20120112-00056_1_2_

    IMG-20120112-00056_1_2_

    interior 2
  2. Interior

    Interior

  3. shop_pics

    shop_pics

  4. Shop Expansion - The block walls 3

    Shop Expansion - The block walls 3

  5. Shop Expansion - The block walls 2

    Shop Expansion - The block walls 2

  6. Shop Expansion - The block walls 1

    Shop Expansion - The block walls 1

  7. Sanders Fine Woodworking

    Shop expansion - The process begins

    Tuesday afternoon and Wednesday, Tony Morrison, my son's new father-in-law, started the foundation for my shop expansion. I am adding a 36' by 48' building with 12' ceilings to my existing 36' by 48' shop. We had to haul in 7 tri-axle loads of dirt to raise the subgrade. Here it is loking back...
  8. B

    Shop expansion started

    Finally getting started on the shop expansion this week, hope the weather holds. Long story but since I live in the Historic District my options were limited by the zoning authorities. Size kept being whittled down so I have ended up with a 16x20 addition to the existing 12x30 building. The same...
  9. Shop expansion

    Shop expansion

  10. buildintechie

    Shop Expansion Progress

    Hey all- My shop expansion is moving right along. It's been awhile since I posted pictures of it, so I'll post some below. I can't seem to find any pictures of the slab...not sure where they got to. The expansion consists of a small 5x12 expansion to my already small 12x12 shop...
  11. B

    wood expansion and contraction

    I am building a cedar chest. The outside is red oak and it will be lined with cedar. Underneath the top is also lined. I was wondering if the two woods might expand at different rates. I am also wondering how I should attatch the cedar. I was thinking about using pin nails and no glue. I'm just...
  12. buildintechie

    Another Milestone on my shop expansion!

    Hello all- Milestone one was getting the new electrical service run. Today, with the help of my battalion chief and another fella from my fire department, we poured the 5x12 slab that will soon be a shed for my DC, compressor, wood storage, and storage for a freezer. Estimated that I needed...
  13. Tarhead

    Shed Expansion Project

    A few months back I posted a question about drying fresh cut pine I got from Randy (woodbutcher). I took the stack/sticker/ratchet strap and spray with Timbor (Borate insect treatment) advice. It was ~12% moisture level the last time I checked it. The lumber is full 2" X 4" and 2" X 6" and dryed...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top