Started to steal Davids thread but figured it was better to start my own.
What is your final grit for sanding cutting boards? Do you wet and sand the boards before final grit? Do you sand between coats of finish?
I have tried tung oil, thinned tung oil and Walrus Oil. I am not happy with any of the three. I know there are a lot of threads about finishing cutting boards but thought I would ask again for suggestions other than the 3 I have tried.
One of the issues II have with tung oil is I can see bright spots which will not rub out. Is this because I am doing or not doing something right?
What is your final grit for sanding cutting boards? Do you wet and sand the boards before final grit? Do you sand between coats of finish?
I have tried tung oil, thinned tung oil and Walrus Oil. I am not happy with any of the three. I know there are a lot of threads about finishing cutting boards but thought I would ask again for suggestions other than the 3 I have tried.
One of the issues II have with tung oil is I can see bright spots which will not rub out. Is this because I am doing or not doing something right?