bowl coring system

[rolly1]

Does anyone know if there is a bowl coring system that will work on a jet midi lathe with 10" swing?

 

[FredP]

you may find one that works but..... I doubt there is enough HP to use it effectively. you would most likely burn the motor up. I may be wrong but thats my opinion for what its worth. I asked this same question on another turning forum a few years back and thats the reply I got from ALL who responded. seems it takes a lot of HP to use these systems. most recomended at least 1 1/2 HP.:dontknow:

 

[rolly1]

thanks for the response I can see where that may be a problem.