Now, no laughing out loud, here's a newbie question for the brain-trust. I have some sheets of 1/2" ply I would like to use on ATV utility boxes. Most boxes are about 12"Hx12"Dx33"W with a hinged lid. The problem is, my ply was stored on edge but still has managed to develop a bow in it:eusa_doh:. I have cut small kerfs in solid wood to solve this problem but only when the kerfs didn't show. I can't do it on these lids because the kerfs will show. Is there any other way to get the bow out or am I doomed to cut it into little pieces for smaller projects? TIA for your suggestions.
Randy
Randy