runout

  1. Rick M

    Nova chuck runout

    I bought a used Nova Midi and first run up there was visible runout so I checked it with a dial indicator. Runout on the outside of the jaws was ~0.040; but is tough to check. Then I chucked a piece of PVC (it was the best thing I could find) and runout was ~0.015. Considering the PVC may not...
  2. Flute Maker

    Runout on Burnring?

    I had put some burnrings on a flute and there was runout...One side of the flute definitely had a bolder deeper ring...Any way to correct this on this flute or disguise it better. I tried making it deeper and I tried darkening it with a pencil and it still isnt quite how I want it. I tried a...
  3. crokett

    Fixing Lathe Run-Out - Fixed!

    Ok... long story but after replacing the head stock belt on a Delta 46-465, which as per the directions involved me whacking the spindle in a vain attempt to get it moved out of one side of the head stock to replace the belt, I put the chuck on the lathe last night and there was a noticeable...
  4. L

    Get rid of the wobble-wobble!

    Ok folks, I just recently rebuilt a 1959 Unisaw (new bearings/link belt/motor/cleaning/etc), but the blade had as much wobble as my old Craftsman contractor saw and it was driving me nuts. I checked the arbor for run-out using a dial indicator. It wasn't too too bad in the .003ish range at...
  5. merrill77

    What is good runout for a TS blade?

    A while back I posted about my disappointment with the sharpening of 2 TS blades. Tonight I measured the runout on them [with my decimal dial indicator:icon_scra] and it came out to 0.004-0.005 in on both blades. To refresh: one of the blades left a very good finished edge requiring little-to-no...
  6. S

    excessive table saw run-out!

    .

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top