hole
-
S
Cutting larger holes with a hole saw
I need some advice on using hole saw to cut 3 and 4 inch holes in 3/4" hardwood. Can I effectively use a whole saw that size with a hand held 3/8 ths drill. I read that you need to keep the rpms down a bit and try not to force your way through the wood. I don't want to spend $50 or more for...- sgtdave
- Thread
- hole holes
- Replies: 12
- Forum: Power Tools and Their Use
-
Corn Hole Boards
Corn Hole Boards I made for the LDS Church- workingwood
- Media item
- boards corn hole
- Comments: 0
- Category: Member Galleries
-
S
suggestions for a 3 1/8 inch hole
I am working on project which requires a 3 1/8 hole. I have a 3 1/8 inch forstner bit, but no drill press. Do have a 1/2 inch power drill that works so-so with the big hole drilling, but using a 1 1/2 forstner bit works better-just have to make more holes. Wondering if I should use a plunge...- Sonny Drake
- Thread
- 1 or 8 hole inch suggestions
- Replies: 4
- Forum: Power Tools and Their Use
-
Bench Dog Hole Spacing
I've been updating my workbench which used to look like this View image in gallery And now looks like this. View image in gallery I'm in the middle of installing a veritas twin screw vise as an end vise on the far end. Then I will be drilling 3/4" bench dog holes. I think I want 4 rows of...- SteveColes
- Thread
- bench dog hole spacing
- Replies: 16
- Forum: Workshop Discussion
-
Post Hole digger
Does anyone in the greater Raleigh area have one I can borrow?- Douglas Robinson
- Thread
- digger hole post
- Replies: 5
- Forum: User Announcements
-
Holdfast test bed - round and square holes
- merrill77
- Media item
- holdfast hole round sqaure
- Comments: 0
- Category: Member Galleries
-
Kreg K3 Jig Hole Misalignment???
Greetings fellow members! I cut my first pocket holes today using the Kreg K3 jig, and I have a question concerning my results. I am using 1/2 MDF (I know I may be asking too much of this jig with the material choice and size) to box a portion of a new mantle shelf. I set the jig up according...- MikeL
- Thread
- hole jig kreg misalignment
- Replies: 20
- Forum: General Woodworking
-
busted routing jig
- eyekode
- Media item
- dog hole square strip
- Comments: 0
- Category: Shop Photos
-
chisel time
- eyekode
- Media item
- dog hole square strip
- Comments: 0
- Category: Shop Photos
-
cut a few more kerfs to make it easy to remove the waste
- eyekode
- Media item
- dog hole square strip
- Comments: 0
- Category: Shop Photos
Premier Sponsor
Our Sponsors
LATEST FOR SALE LISTINGS
-
-
-
SOLD -- $75: Gast moa v113 Vacuum Pump Veneer, 60" bag and board- Started by peterdnight
- Replies: 1
-
GONE: Gladiator 5 cleats, 10 hangers, Paper Towel and Shelf
- Started by peterdnight
- Replies: 3
-
SOLD -- $100 Makita mac700 portable air + grex pin nailer + 2 others + 50' hose
- Started by peterdnight
- Replies: 1