half

  1. L

    Half mitered lap joing

    Does anyone have any hints on achieving the perfect half mitered lap joint? I have used two versions from Woodsmith and come along fine until the mitered cuts are made to join the pieces together. They are lined up looking from the rear of the tablesaw even with the corner, looks simple but I...
  2. brenthenze

    new barn/workshop: the easy half is finished!

    All, Thought some of you might like to see pictures of the new barn/workshop as it goes up. So far I'm about halfway done, but it's the easier half: the slab (which I hired someone else to do), the walls, and the second story floor (aka first story ceiling joists). Three trusses are up, but...
  3. Mike Davis

    Small bowl - Half finished

    This is going to be a wedding present for an old friend in England. It's only half finished, I'm going to do some carving on the rim. Curly Eucalyptus, 11 x 4.5, oil finish, 1/2 inch thick as it is a serving bowl and will be used daily.
  4. J

    Gas heaters half off at Lowes

    Was in Cary and Garner (Hwy 70) Lowes on Friday. They are clearancing seasonal heating devices - half off. I have one of the infa-red plaque heaters in my shop and love it. They have both 18,000 BTU and 30,000 heaters. I have the 30K in my shop. Both have a thermostat built in. Smaller unit says...
  5. LeftyTom

    I Had the Mortise Half Done

    Then everything went black (I work in the basement). Just enough light coming through the door for me to check the breaker panel (nothing tripped). Well the neighborhood and the street over were without power for 2 hours. No doubt, some mischievous squirrel was intent on spoiling my...
  6. FredP

    a box half a%%ed finnished

    playing with some long lost inlay tools. had a few blunders but they fixed!:icon_thum i learned that a new inlay will fix a screwed up one and look like it was intended!:rolf: looks blotchy cause its only the first coat of oil and it aint dry. i hope.....:roll:
  7. LeftyTom

    Claiming Half the Basement

    I am working on setting up shop in the back part of my basement. It is about 24' x 14', which (wouldn't you know it) sits under our living room and kitchen. There are no windows in the basement, save for the door. I will have an electrician run me a 220V 20A circuit (2 dual outlets) and...
  8. R

    Resaw it for me and I will give you half

    Not real sure where this topic should go so if this the wrong place I apologize. I have some rough cut cedar that I need re sawed. It about 16 feet long , 3 boards are 11 inches wide, 6 boards are 6 to 7 inches wide. It is all about 1 1/2 inches thick. This is 98% clear wood, very few knots. You...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top