breadboard

  1. M

    Help with breadboard ends

    I'm looking at this thread and was wondering if anyone could help me with attaching breadboards ends the same size and width as in the picture. Thank you! http://www.ncwoodworker.net/forums/showthread.php?t=47364&
  2. Jim Murphy

    Tips on securing tabletop breadboard

    Darn... it turned out much better than expected. SO.... I know I need to glue and pin the center board, but any tips or tricks on pinning the outer edges? REMEMBER, we're dealing with discount walnut here. (Wow...I had a B eye Tee Sea Haitch of a time getting enough of Charlie's walnut to...
  3. F

    Glue REPAIR HELP - breadboard with inlay strip

    I built a kitchen table (purple heart top w/ breadboard & a hard maple base) in 2005. The table although wearing well has two issues I'd appreciate suggestions to resolve. 1. When I built the table, I routered a small channel along the inner edge of the breadboard and rolled/glued in an inlay...
  4. sediener

    Breadboard question??

    Can I get away with only gluing the center tenon and skipping the pegs or are the pegs central to its stabilizing effect? I've got an 18.5" wide panel with a 5" wide center tenon and 2 -3" side tenons all 1.75" deep into the breadboard. thanks,
  5. Gofor

    Breadboard ends

    Working on a table top. Went through the following steps: Did I do it right? Go
  6. Bedside Table Top

    Bedside Table Top

    Top showing breadboard construction
  7. L

    Breadboard assembly question

    I am just getting ready to cut my tenons and the mortise for my trestle tabletop and would appreciate some help. I have made two breadboards in the past, one for the trestletable top for my son and his wife and I also made one for the walnut secretary. This top has two sections with a 5"...
  8. L

    Setup for tenon for breadboard?

    I used a breadboard on my secretary last summer so I know how to setup the tablesaw for the tenon however before making that cut on my tabletop I would like some advice. This tabletop is 38" long and 28" wide. I would like some suggestions as to how to safely and accurately setup for the tenon...
  9. pslamp32

    Breadboard question...

    Do you need to put breadboards on coffee table ends? I see them mostly on dining room tables. I'm making a coffee table out of a 8/4 piece of Sapelle 16X48". It's all one beautiful piece of wood, no glue up. Thanks! :-)
  10. Matt

    Breadboard Question

    It has been a while since I have been on this board, miss you guys. Work and hunting season have conspired to keep me out of the shop... Anyway, I am getting back to work on a hall table. It is ambrosia maple with breadboard ends (my first attempt at breadboard ends). There is a 3/4" strip...
  11. L

    Breadboard application question

    I have planed a top for the walnut chest that is 5/8 inch which will have a breadboard attached to the outer edge. It was to be 3/4 inch thick but after a few curves I found myself with 5/8th. Now that the jointer is set up properly I could make the panel again if necessary. With 5/8th thick...
  12. DaveO

    Breadboard end tenons

    What's the best way to cut them? I have considered a dado set, but mine sucks and I wouldn't feel comfortable moving a 40" wide by 15" deep piece accross the tablesaw. I don't have a rabbet or shoulder plane so the by hand method is out. I am seriously considering a router with a straight edge...

Premier Sponsor

Our Sponsors

Top