bob

  1. Joe Scharle

    Happy Birthday Bob Wingard

    :new_birth:banana:
  2. eyekode

    Thanks Bob (was: Help I am skew'd!!!)

    I recently started turning but I have cleared the event horizon and there is no escaping the vortex now :). I don't have a chuck yet so I have been practicing turning spindles. The gouges seem simple enough in use once I got them sharpened. The skew however is a different beast. Planing cuts...
  3. R

    Moved Bob's thread on injured hand

    Bob C posted a thread called Pain of Stupidity. http://www.ncwoodworker.net/forums/f83/pain-stupidity-32633/ Since it was about a shop accident, I moved it to the Safety forum. I sent him a pm to explain: Bob, I moved your thread to the Safety and Health forum. It's where members post...
  4. R

    Happy Birthday, Bob Wingard

    Bob, Here's hoping you have a terrific birthday today. :new_birth:new_birth:new_birth
  5. Messin around in the woodshop

    Messin around in the woodshop

    Ready for the great white north
    • woodArtz
    • Media item
    • bob jim
    • Comments: 0
    • Album: NC Woodworkers
  6. bobby g

    My name is Bob and I'm a woodworker

    My screen name is bobby g and I've been a member for some time now but just hadn't taken the time to introduce myself. A year before my retirement in 1990, my wife Sandra and I moved from Painesville (a little east of Cleveland), Ohio. Sandra was born in Pittsboro and is a UNC graduate so I'm a...
  7. DavidF

    BobCat Bob injured

    I just heard from Carol, via his wife that BobCat bob got pretty badly injured by his bandsaw the other day. Nearly sliced two fingers off on his right hand while sawing a turning blank. It was during the snow so his wife had to try and get him to the emergency room on really bad roads. They...
  8. JackLeg

    Bob's Oak Table

    Here's a shot of the 5' oak table top and Lazy Susan Tom and I built for his Uncle Bob. The top and Lazy Susan are made from locally sawn white oak boards that we planed to a uniform 3/4". The boards were all 6" in width. We used a reverse glue joint bit to joint the boards and Tite Bond...
  9. 9b) southwest corner

    9b) southwest corner

    I picked up a DW 712 SCMS and a Ridgid MSUV stand last year for pretty good prices. Using Incra shop stop fence, I made pretty accurate fence and stops (I did same on RAS). I can just set the stop on the spot and get the measured piece I´m after. I´m now using the SCMS for my miter cuts and...
    • docksider
    • Media item
    • 712 bob dw jig scms wolverine zajicek
    • Comments: 0
    • Category: Member Galleries

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top