inserts

  1. L

    Zero clearance table saw inserts

    I have seen in several books a good way to install shop made table saw inserts is to use hot melt glue to level. Is there a trick? I have use too much glue, too little glue and have yet to get one level. Do you put the glue on the insert first or the saw supports. I can see were this...
  2. Flute Maker

    Anyone Used the Tools with Carbide Inserts?

    Has anyone used the turning tools with replaceable carbide inserts ? How did they perform ? Pros and cons of them. And who makes the best one for the money ? Thanks Everybody !
  3. S

    Inserts

    Hello, I saw a post in this forum the other day about making either staffs or canes, and someone gave a link to some nice inserts for the pool cue type connection. Does anyone know what the link was to that item? I've been using the gold inserts you find at woodcraft and would like to give these...
  4. NCTurner

    Homemade chuck, deal on 1-1/4"x8 Inserts

    I was looking for something to use to make some shopmade chucks for the PM, and came across these cheaper than a nut of the same size and MADE for the lathe. I plan to insert these into a block of wood and make some wooden faceplates, I will drill and tap a small hole for a set screw in the base...
  5. RandyJ

    What makes TS inserts grow????

    This has me stumped:dontknow:! I have a Delta Contractor Table Saw purchased about 3 years ago. I replaced the standard inset with a Zero clearance insert almost immediately. Now, 3+ years later, I tried to put the original insert back and it's too BIG! I've checked/cleaned both the insert and...
  6. mshel

    Large size threaded inserts

    I am looking for some large, ie 3/8" or larger threaded inserts. I am coming to Raleigh tomorrow and just wanted to know who might have such an animal so I don't burn a lot of gas chasing ghosts. I will be using the inserts and hanger bolts to repair a king size bed for a client who wants to...
  7. bman

    woodpeck router table inserts

    :eusa_thin hey guys any of yall ever use or have one of these http://www.woodpeck.com/aluminsert.html trying to see if the are any good or not
  8. chris99z71

    Corian zero clearance inserts

    I got this 24x40 piece of corian from the Habitat re-use center for $7. It made several really nice zero clearance inserts. Notice the holes for set screws. Who would have thought that you could tap corain and it would hold! I put a dado in the edge and epoxied in two magnets. It doesn't...
  9. RandyJ

    Home-made zero-clearance inserts for TS

    Another newbie question for the brain-trust! I thought I'd try to make my own ZCI for my 10" Delta X5. I got the tip from Michael Gardner's reply to another question on inserts. Thanks Michael:icon_thum ! So, I bought a cutting board at Walmart (Poly) but when I cut it, there was a bow in the...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top