holders

D
exotic toothpick holders

These were made as gifts, but had to keep one for myself. The Madrone burl was probably the hardest to make, as I made it on my old lathe and drilled out the center on my drill press. The wood got so hot that I could only drill about 5 sec., then let it cool for 3 or 4 minutes. It took most...
- Dave Peterson
- Thread
- Dec 22, 2011
- exotic holders toothpick toothpicks
- Replies: 5
- Forum: Woodturning
HF Lathe Shelf

HF Lathe Custom Wooden Shelf with PVC tool holders
- Badabing
- Media item
- Jul 16, 2010
- custom hf holders lathe pvc shelf tool with wooden
- Comments: 0
- Album: My Shop
Toothpick Holders

First Projects
- ryanmcombs
- Media item
- Dec 21, 2009
- holders toothpick
- Comments: 0
- Category: Member Galleries
Pen & Pencil "holders"

I was on a non-woodworking site (yes, they do exist) this morning and found pen and pencil covers. You take the caps of stick pens/pencils and put them inside of the fancy holders. I don't if they have mechanisms in them - for a mere $29 they can be individually purchased. Thought these...
- cskipper
- Thread
- Dec 12, 2009
- holders pen pencil
- Replies: 0
- Forum: Woodturning
Pictures of your scroll saw blade holders, please

You may have seen my recent gloat about getting a good saw and asking if anyone had experience with the Pozgai Designs aftermarket blade holder. The saw I got is the "Contractor series" Craftsman VS 20. Except for the blade holder, I would put it in the class of the DeWalt or Delta P20. The...
- CarvedTones
- Thread
- Jun 24, 2009
- blade holders pictures scroll
- Replies: 7
- Forum: Scrollsaw Work
Ring holders

I could swear that there was a post about how some member made ring holders for jewelry boxes, but for the life of me I can't find it. I am looking for hints to the construction of a fabric covered foam block with slots in it to hold rings upright...any clues??? Maybe it was Toolferone??? I'll...
- DaveO
- Thread
- Jul 16, 2006
- holders ring
- Replies: 5
- Forum: General Woodworking