degree

  1. 45 degree mortises

    45 degree mortises

    I used the jig shown to hold the leg billets at 45 degrees on the mortiser table. The apron tenon pattern is shown in the top of one mortise.
    • Charlie Buchanan
    • Media item
    • 45 degree mortises
    • Comments: 0
    • Album: Dropleaf card table
  2. L

    45 degree mitre joints

    I have been cutting 45 degree mitre joints on my table saw and they have been OK. Do most wood workers use the table saw or the mitre saw to cut the 45 degree joints. I'm thinking about up grading my mitre saw to see if I can get tighter joints.
  3. PChristy

    67.5 degree cut

    anyone got a safe way to cut this angle - All I have to cut it with is a mitersaw
  4. M

    20 degree angle on chisles??

    I got several chisles at a garage sale yesterday that are ground to a 20 degree angle. the faces of all the chisels were chipped and look like they had 32 tpi on the face. well I cleaned they up and tried one, edge rolled and chipped , the chisles have a blade about 6 inches long and thin. all...
  5. S

    50% Off 90 Degree Angle / Corner Clamp Package Peachtree

    E-Direct Special ED-011910 Phone Orders 1-888-512-9069 Tech Support : Customer Service 50% Off 90 Degree Angle / Corner Clamp Package This 4 Pack of our 90˚Angle clamps features the power flex handle, which allows you to pull the handle out and rotate it to apply extra holding power...
  6. T

    3HP Porter Cable Router will only adjust 180 degree in housing

    I built this router station last year and it is practically brand new. The router (3 hp Porter Cable )motor seams to have jammed in the housing. I can only turn it 180 degrees so I can not even remove the motor.:BangHead::BangHead::BangHead: Anyone else had this problem? Should I put it in a...
  7. Canuck

    Biscuit Cutting 45 Degree Bevel

    Had a bunch of biscuit slots to cut at 90 degrees to a 45 degree bevel. Rather than totaling relying on the fence on the biscuit joiner, I constructed this little "sled" from from some "scrap BORG 3/4 ply". I was able to to cut all of the slots in the bevels perfectly centered on the...
  8. L

    How to repeat 45 degree angles

    I am cutting molding for frames and running into a problem. I have a miter saw that I am using but don't know how to repeat the angle each time. When you slide from right to left and back again there is no way that I know to always go back to the same exact place. I am only looking at the...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top