Wood for turning

[Roy G]

A few days ago there was a post about wood suitable for turning which I can't seem to find. One of the responses came from Mike Davis saying he could use some 2" and 3" stuff. I looked through my shed and found I had quite a few pieces of black walnut. Minimum thickness was 1 1/2" and it went up to 2 3/4". Widths varied from 2" up to 4 1/2" and lengths went from 17" to 38". A total of 27 pieces. So I have it all off the shelf and in the way. I figured if you are interested and could pick it up I could give it to you and you could give a donation to the site. If you only want a few, that's okay too. Eighteen of the pieces are around 24" or slightly less. Nine run from 32" to 38".

Roy G

 

[David Turner]

Roy: If no one else takes it I will. And somehow I will get it to Mike.
David

 

[Roy G]

I'm over to the east of Jordan Lake, just inside Chatham County. When could you stop by? Mike indicated he was interested in 2" and 3" stuff and that's a few of the pieces. Don't know what length he needed.

Roy G

 

[Mike Davis]

Roy,
I can come over there after work tomorrow. I’d have to check google to see how long it would take.

PM your address if that’s ok.