Saw this on another forum and figured some of us might want to know too ...
http://www.tormek.com/en/jigs/svd180/svd185_arrow.php
Manufacturing error SVD-185
A manufacturing error has been discovered on jigs delivered between January 1st and September 22nd 2009.
On these jigs the setting arrow has been shifted and is located about 16 mm (5/8") from the edge. The arrow should be 20 mm (.79") from the edge. This error causes the profiles to differ from those in the instruction.
If you have one of these jigs, you can either make a new mark yourself with a marker pen or contact Tormek to receive a label which you can attach to the jig with the correct position of the arrow.
Tel: +46 581-147 90
Fax: +46 581-109 30
E-mail: webmail@tormek.se
http://www.tormek.com/en/jigs/svd180/svd185_arrow.php
Manufacturing error SVD-185
On these jigs the setting arrow has been shifted and is located about 16 mm (5/8") from the edge. The arrow should be 20 mm (.79") from the edge. This error causes the profiles to differ from those in the instruction.
If you have one of these jigs, you can either make a new mark yourself with a marker pen or contact Tormek to receive a label which you can attach to the jig with the correct position of the arrow.
Tel: +46 581-147 90
Fax: +46 581-109 30
E-mail: webmail@tormek.se
