Calling the thread fit of the spinners on the screw “sloppy” would be a compliment. But, that is why they spin so freely.
The clamping screw needs to be perpendicular to the leg. The rear nut (spinner) is housed in an adjustable housing so that misalignment like this can be adjusted out despite the loose thread fit.
Note that this is the initial adjustment. The final adjustment is made with the weight of the chop in place.
The clamping screw needs to be perpendicular to the leg. The rear nut (spinner) is housed in an adjustable housing so that misalignment like this can be adjusted out despite the loose thread fit.
Note that this is the initial adjustment. The final adjustment is made with the weight of the chop in place.
Last edited: