I'm looking to replace the generic 10" blade that was on my saw when I got it with something decent.
I have an old Craftsman 113.27520 table saw, circa 1956. It has a 1 HP motor. I would like a general purpose blade for now. I hear good things about the Forrest Wood Worker II. Not sure if I should spring for that over a cheaper Freud blade. Also should I go with thin kerf based on my small-ish sized table saw motor?
I have an old Craftsman 113.27520 table saw, circa 1956. It has a 1 HP motor. I would like a general purpose blade for now. I hear good things about the Forrest Wood Worker II. Not sure if I should spring for that over a cheaper Freud blade. Also should I go with thin kerf based on my small-ish sized table saw motor?