new outfeed/assembly bench

[jahrules]

so, I'm gearing up for a cabinetry project and I was thinking about having to cut cabinetry grade plywood. Until now the only ply I have cut is for shop fixtures so I haven't been awfully concerned about the edges being 100% dead on and such. As such, I decided that my outfeed system (basically a metal stand with a box sitting on it) wasn't going to cut it anymore.

Well, they say something isn't worth doing unless it's worth overdoing, right?

'nuff said.

the following is a full 4' x 6' made from 3 sheets of 3/4" ply. I am strongly considering laminating the top before its all said and done.

 

[bobby g]

That looks good Greg and it will make your work much safer and easier too. I'd go ahead and put a laminate on it while you have the chance.

bobby g

 

[Joe Scharle]

Looks super solid!

 

[MarkE]

That looks solid as a rock! :icon_thum

 

[Canuck]

Looks great and solid enough to act as a assembly table as well.

+1 on adding a sheet of light colored laminate.

Wayne