Here are pictures of the bench I just finished building. I made a face vise that attaches to the bench by means of two oak butterflies. It also supported underneath. It lifts out very nicely.
Gene:
Thanks - 'I believe I gots it'
You mention in the OP that this vise is "also supported underneath" - care to elaborate so I can envision how I might implement?
Thanks, makes sense.I cut a 2x4to match the angle of leg put it under the secured portion of the vise and screwed it to the leg. As you may or not know, the legs are cut on a 15 degree angle so the underneath support is cut on the same angle. This supports the vise if you are chopping a mortise. I frankly would never do that but someone might. With combination of the butterfly and the underneath support the vise doesn't go anywhere.