Wanted to use my 1 day off this week to make some headway on the entertainment center I have started, it's been slow going on this project.
Selected the boards for the base, cut to rough length, jointed, planed, and ripped to width and cleaned up. 1 board about a half inch too short. Now how did that happen :dontknow:. Grabbed another board solved the issue, cleaned up chips again.
Set up router table to cut the rabbits and got a fair amount of tearout on the last board of course. Came up with a solution routed out the rabbits a second time, so what if the base is 3/32 inch lower than I had planned, I'm the only one thats going to know but more time wasted.
Set up router table to rout the outside profile then all I have to do is cut to final length and attatch. Well halfway through the third board the router dies.:BangHead::BangHead::BangHead::BangHead: The project is dead in the water. Now I guess its to the Dewalt service center in Greensboro Monday cuase its only a year and a half old.
Selected the boards for the base, cut to rough length, jointed, planed, and ripped to width and cleaned up. 1 board about a half inch too short. Now how did that happen :dontknow:. Grabbed another board solved the issue, cleaned up chips again.
Set up router table to cut the rabbits and got a fair amount of tearout on the last board of course. Came up with a solution routed out the rabbits a second time, so what if the base is 3/32 inch lower than I had planned, I'm the only one thats going to know but more time wasted.
Set up router table to rout the outside profile then all I have to do is cut to final length and attatch. Well halfway through the third board the router dies.:BangHead::BangHead::BangHead::BangHead: The project is dead in the water. Now I guess its to the Dewalt service center in Greensboro Monday cuase its only a year and a half old.