Latest Turning
- Thread starter Charlie
- Start date
- Status
Yea, I don't get that either since they are in your gallery (where I picked them up for my post - need to get Ethan on the case...)
I mentioned this recently that certain threads are dropping pictures, but didn't have a good example... now I do!
Just to be clear you uploaded the photos to your gallery and then clicked on the camera icon above and clicked on the picture to put it in the post, right?
Thanks again for the comments.
Joe, I am slowly decreasing my collection.
Jeremy, I start by setting the fence from the angle drawn on an 8 x 11 paper drawn in Auto Cad. Once I set the fence I cut enough segments from 1/4" x 3" MDF strips to complete a quarter ring. I then tape these segments together and check that they make a perfect 90 degree angle. If not I do some tweaking by trial and error.
Hank, Yes I did just as you said.
Joe, I am slowly decreasing my collection.
Jeremy, I start by setting the fence from the angle drawn on an 8 x 11 paper drawn in Auto Cad. Once I set the fence I cut enough segments from 1/4" x 3" MDF strips to complete a quarter ring. I then tape these segments together and check that they make a perfect 90 degree angle. If not I do some tweaking by trial and error.
Hank, Yes I did just as you said.
- Status
