HELP!!!
when straightening up after yesterdays project, I stored my clamps in a standing position, like Alan has in his clampstand. (IIRC, he has jorgies, too?)
unfortunately, one of the clamp heads decided to lock into full closed position. Any ideas as to how to fix this? I have fussed with it enough to see that I have about 1/32" play between the clamp-pads, and I can turn the adjuster about 2 or 3 turns, but I cannot open it up!
anyone run into this before? will I need a hydraulic press to drive out the pins from the fixed head?
when straightening up after yesterdays project, I stored my clamps in a standing position, like Alan has in his clampstand. (IIRC, he has jorgies, too?)
unfortunately, one of the clamp heads decided to lock into full closed position. Any ideas as to how to fix this? I have fussed with it enough to see that I have about 1/32" play between the clamp-pads, and I can turn the adjuster about 2 or 3 turns, but I cannot open it up!
anyone run into this before? will I need a hydraulic press to drive out the pins from the fixed head?