Great use from my router table

[tvrgeek]

Need I say more

 

[Henry W]

Need I say more

I have a lathe in similar - no make that much worse - condition.

 

[Rwe2156]

I don't see anything unusual.................

 

[creasman]

You need a sticking board to clamp on your router table! See Queen Anne Desk

 

[Martin Roper]

Scott, I'm pretty sure I saw a proper workbench in your shop...

 

[tvrgeek]

Yes, and it is piled high with the project. Actually the height of my saw/outfeed/router I find more comfortable for a lot of uses so I use both depending on the job.

I like that sticking board. My face vise is in the way of better placed dogs. This particular job was beading some 3/16 thick stock and the overhang was necessary. So I modiufied a T-Track clamp to run in the table miter slot. Worked great.

What I learned is I should assemble all the pieces of a picture frame into long stock, then cut the lengths in one go. Eight more frames to go.