urethane

  1. Volksdad

    Setting up and tuning a ridgid 14" bandsaw

    I bought my saw in early 2006 on a closeout, and moved to NC and packed it in a shed. Earlier this month I started setting up my TINY shop, and it was time to set up the bandsaw. After my initial assessment, I finished putting it all together per the manual, and found the yellow safety key...
  2. S

    Rockler: Urethane wheels $1.99 (69% off)

    DEEP discount. Not bad price IMO... especially with bearings. Would come to about $13 for three with S/H. Less great of a deal, but if you're already shopping there.... ;) http://www.rockler.com/product.cfm?page=30216
  3. Scrollsawn Nativity

    Scrollsawn Nativity

    scrollsawn nativity
    • sbarnhardt
    • Media item
    • nativity oak pine scrollsaw urethane
    • Comments: 0
    • Category: Member Galleries
  4. thrt15nc

    Grizzly G0555 bandsaw and urethane tires

    Has anyone bout urethane tires on their G0555 bandsaw? I fos, what size and who'd you get them from? I called LV and they weren't too sure their 12 inch urethane would stretch far enough to go on it. I measure the wheel diameter at 13.3 inches. While I'm at it. Anyone replaced the guide...
  5. J

    Urethane band saw tires

    Hi all, i purchased new Carter urethane band saw tires and have a question. My wheels are one inch wide and the new tires are an inch and a half wide. Must I leave a quarter inch overlap on each side and trim off, or can i trim all on one side? Or, do i need to get same width tires and my...
  6. K

    General Finishes Gel Topcoat Wipe on Urethane

    Anyone use this? Bought some GF gel stain, from WWS, and saw this listed as a good finish for the gel stain. Should have paid a little closer attention. I thought it was a finish for use over gel stain. It is actually a "gel" wipe on finish. Sure was a surprise when I opened the can. The...
    • Keye
    • Thread
    • finishes gel general topcoat urethane wipe
    • Replies: 1
    • Forum: Finishing
  7. J

    Are urethane bandsaw belts worth the expense?

    Hi all. New member here. I recently bought a "homemade/kit" bandsaw with 18 inch wheels and was wondering if the urethane belts are worth the expense. My top belt seems ok but the bottom one looks as if it might split at any time so was also wondering if I can replace 1 at a time or do I have to...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top