freight

Y
Feedback on Harbor Freight Jointers

I was given a "New in the box" 6" jointer by a friend as a thank you for helping him with some work. It is one of the Central Machinery jointers sold by Harbour Freight for $289.00. I'm looking for tips and pointer from any problems these units may have. I did assemble the unit and after...
- yellofins
- Thread
- Mar 25, 2006
- feedback freight harbor jointers
- Replies: 24
- Forum: Power Tools and Their Use
Harbor Freight Plate Joiner

Well I did it again! I'm not a big fan of bisquits as a rule, but for holding the ends of large picture frames while glueing they're hard to beat. Recently, I built a frame that was so big it was hard to hold on the router table to cut the slots and I made one really long! Then I saw a plate...
- Joe Scharle
- Thread
- Mar 13, 2006
- freight harbor joiner plate
- Replies: 1
- Forum: Reviews
Harbour Freight DT Jig

I just couldn't help myself. When I got an email from Harbor Freight selling this jig for $29.00, I had to see it. First, it weighs a respectable 20 lbs., has lots of knobs and some levers that appeal to the engineer in me. The comb was as expected, rough. 5 minutes with a ROS and light filing...
- Joe Scharle
- Thread
- Jan 28, 2006
- freight harbour jig
- Replies: 32
- Forum: Reviews
4) north wall east side

Here´s my RAS station. This was my first stationary tool (1984). I don´t regret any of the space it occupies. My 6" HF jointer slips nicely in front of the narrower right side extension. Next is the Jet 1236 lathe (which is hard to see, but tucked behind the RAS where it resided until I...
- docksider
- Media item
- Mar 26, 2005
- arm drill freight harbor jointer press radial saw
- Comments: 0
- Category: Member Galleries