bolts
-
1/4-28 bolts in Raleigh/Apex area
I need some pretty long 1/4-28 bolts (2.5" - 3"). I tried HD and Lowes and of course they don't have'em. I will try ACE tomorrow, they typically have a little better selection. Any other local places I should try? Thanks!- eyekode
- Thread
- area bolts raleigh or apex
- Replies: 9
- Forum: Where Can I Find, Buy or Sell?
-
Where is best selection of bolts and screws
I am looking for a specific metric screw. Must be wafer head or have extremely low head profile. The size is M6x1.0, either 40mm or 50mm. I can easily find these screws online but not with the wafer head. In a pinch I would even try a 1/4-26 screw, but again must be wafer head.- roweathers
- Thread
- bolts screws selection
- Replies: 10
- Forum: Where Can I Find, Buy or Sell?
-
M
Looking for bed-frame type bolts
Hi Guys, It has been a while since I have been to the sight. Life has gotten very busy. I have moved to Hillsborough and am enjoying the change of pace. In preparing for the move, I disassembled our dining room table. It is a teak Scandinavian table I bought at Danco on Hwy 70 about 15...- MarvinWatkins
- Thread
- bedframe bolts type
- Replies: 8
- Forum: Where Can I Find, Buy or Sell?
-
T-Track Toilet Bolts
Article by Joe Scharle- Terry
- Media item
- bolts toilet
- Comments: 0
- Category: Member Galleries
-
J
Nuts, Bolts, HDPE, and T-Track
Most jigs require one or the other of all the above. Agri-Supply in Garner carries nuts, bolts, washers, locking nuts, carriage bolts, BY THE POUND. This sure beats the heck out of going to local hardware/Borg and paying a buck for one bolt when you can buy them by the pound. They also carry a...- junquecol
- Thread
- bolts hdpe nuts ttrack
- Replies: 10
- Forum: User Announcements
