base

  1. Jet JWBS-16 Band Saw

    Jet JWBS-16 Band Saw

  2. Jet JWBS-16 Band Saw

    Jet JWBS-16 Band Saw

  3. Mounting Bolt

    Mounting Bolt

    Machine is anchored to the universal base with four 3/8'' x 1-1/2'' bolt - with flat and lock washers. Wooden spacer block ( 4-1/4' 'x 5-1/2' 'x 3/4')' provides clearance for 3/8'' nut welded to the HTC corner platform base.
  4. Rear wheels.

    Rear wheels.

  5. Raised Postion

    Raised Postion

  6. Lowered Position

    Lowered Position

  7. Jet JWBS-16 Band Saw

    Jet JWBS-16 Band Saw

    on Earlier version of the HTC 2000 mobile base.
  8. Current to scale design

    Current to scale design

  9. Table base @ 19"

    Table base @ 19"

  10. Shelf project 1

    Shelf project 1

    Overall view of the installed shelves with window. Window treatment and carpet were not complete when this photo was made. The base cabinets were installed and leveled first. The top arches/corbel assemblies were fitted on site to accommodate ceiling variation. The center arch board is about...
  11. Right unit library shelves

    Right unit library shelves

    Right unit of the shelves. The chase built into the wall at right conceals refrigerant and condensate lines for the heatpump/AC unit.
  12. Left unit library shelves

    Left unit library shelves

    The depth of the unit was limited by the closet door seen at left. Total unit dept is 9 3/4 in. height to ceiling is 99 inches.
  13. Detail of base cabinet door pulls

    Detail of base cabinet door pulls

    Shop made door pulls for cabinet doors. They have a round finger groove underneath the pull.
  14. Right base cabinet for library shelf project

    Right base cabinet for library shelf project

    View of the right base cabinet on my bench after mounting doors, but before the pulls were attached. Hinges are soft-closing cabinet hinges for flush inset doors. The raised panel doors and face frame are cherry while the case is cherry veneer plywood.
  15. Shelf unit project detail

    Shelf unit project detail

    Detail of corbels at top of shelf case
  16. IMG_20120605_180823

    IMG_20120605_180823

  17. IMG_20120605_180808

    IMG_20120605_180808

  18. IMG_20120605_180758

    IMG_20120605_180758

  19. O

    Cove Style Base Cap

    Redoing the trim in the house maple 1x6 with Walnut Cove Style Cap. Anyone out there have a good source that could fill an order like that?
  20. MarkE

    Mobile Base oops

    I got the Shop Fox D2058A mobile base for my G0524X band saw. This is the mobile base reccomended for this saw by Grizzly. Tried to open the lower door yesterday and discovered this little oops. View image in gallery View image in gallery The bolts the secure the rails to the...

Premier Sponsor

Our Sponsors

Top