Not real sure where this topic should go so if this the wrong place I apologize. I have some rough cut cedar that I need re sawed. It about 16 feet long , 3 boards are 11 inches wide, 6 boards are 6 to 7 inches wide. It is all about 1 1/2 inches thick. This is 98% clear wood, very few knots. You may cut it to any lengths you need to to re saw. All I want out of it is standard width 8 foot boards. I realize it may not be able to be re sawed to all 3/4 inch thickness for all pieces. But I need it 3/4 inch width. I really hate to plane it all down to that thickness. Only other thing I ask is that you have done this before. It really is very good cedar.