Corner cupboard--door #2 dry fitted

[JimReed2160]

Another hour in the shop means a chance to trim panel #2 and dry fit it in the door. The LN #62 plane did a masterful job at raising the panel and also trimming all the sides to fit. Now both doors are dry fitted. Here is the money shot of them in place.

Next job is to put finish on the pieces and then glue up the mortices and tenons. I am planning some red stain for the walnut, BLO for the maple, and poly for both. Finishing might be easier if I do some of it before glue up.

 

[ptt49er]

Looking good! It's nice when you have light at the end of the tunnel isn't it.

 

[JimReed2160]

It is nice to see it moving along. I started in 2004 & picked back up last summer. Once I finish the bottom, it will be too hot to work much in the shop, so it may be some time before I start on the top piece.