200 BF 4/4x6-8 SYP

[CrealBilly]

Hi... I'm looking for 50 SYP 4/4 x 6" x 8' KD rough cut with smaller knots and no blue stain. Mill run is fine as long as there's not to many pithy boards.

Thanks

 

[saw4you]

Jeff, I can have them for you tomorrow .50 b/f

Jack

 

[CrealBilly]

Jeff, I can have them for you tomorrow .50 b/f

Jack

I didn't call you because I didn't think you would have any kiln dried SYP laying around - do you?

 

[saw4you]

Jeff, I do not have any laying around but I can dry some for you if you can wait

Jack

 

[CrealBilly]

Jeff, I do not have any laying around but I can dry some for you if you can wait

Jack

Jack Thanks for taking my call yesterday, your not only saw4you your also dry4you After doing some re-estimating I'm going to need 250BF. It'll need to be a good strong 4/4 (1 1/8") so I can wind up with 3/4" dressed after glue up. I'll give you a call in the next few days to confirm my order and get an ETA.

Thanks Again Jack

 

[CrealBilly]

I picked up 250 BF of 4/4 x 6 SYP from Jack this afternoon. Much to my surprise all the boards measured consistently @ 6% moisture content. I worked a few boards this evening, they skipped @ 1 1/16 thick, I should have very little problems getting a good solid 3/4 panels out of the lumber. I have a 8' long 25" wide panel in clamps right now.

Right nice stuff Jack thanks man :thumbs_up