Which Router Fence?

[MikeF]

I am looking for a new Fence for my router. I have a Jet table saw that has the router table built into the extension, like this one..

Which fence would you recommend for this type of setup? I looked at the Woodpeckers super fence, but am not sure how that would mount on this type of setup.

Thanks,

-mike

 

[Travis Porter]

I am preferential to this one.

Not mine and I am not affiliated with its owner.

It was made by our member Monty. He has lots of additional photos in his gallery.

 

[Keye]

Really not trying to be a smart.... but 90% of the time I use a notched 2X4 and two clamps. Dust collection is a bummer but other than that I have not found anything that I need to do which can not be done this way. I do have an Incra but it just collects dust, on itself.

 

[MikeF]

I have also been looking at the Incra LS, like the one in John's post.

http://www.ncwoodworker.net/forums/f29/first-incra-dovetails-19047

It seems to take up a lot of space behind the router plate. In John's picture it looks like it is also mounted on the table saw extension, but in reverse to my setup.

John, after using for a little while, would you recommend?

-mike

 

[Jim M.]

Mike,
I'm putting together the same setup right now for my Jet saw. After some research, I decided to go with the Freud fence below. I'm using the same nut-sets in my table so I can free up the table surface for long stock by removing fence easily. Hope this helps. Jim

Amazon link

 

[McRabbet]

I have a Jointech Cabinetmaker's Fence System and I've been very happy with it. Very accurate and stable. I've had it for at least 5-6 years.