I uncovered a section of pith when I cut the oval into my rectangular table top glueup. :eusa_doh:
Here's a pic.
The pith area is the round one near the center of the pic. The other light colored areas are just the rough edge from the jigsaw, I haven't shaved that area flat yet.
I intend on rounding the edges and am concerned that I'll open up a mess. Any thoughts of fixing this?
I know I can always use a guide and skilsaw and rip the bad area out and glue in another piece. If I do then I think edge jointing will be difficult since the table top is pretty big to run on the jointer and I don't have enough confidence in my No. 7 to joint edges for an 80 inche glueup.
Any ideas? Superglue...epoxy? Large forstner bit then glue in a plug? I'm open to suggestions.
Chuck
Here's a pic.
The pith area is the round one near the center of the pic. The other light colored areas are just the rough edge from the jigsaw, I haven't shaved that area flat yet.
I intend on rounding the edges and am concerned that I'll open up a mess. Any thoughts of fixing this?
I know I can always use a guide and skilsaw and rip the bad area out and glue in another piece. If I do then I think edge jointing will be difficult since the table top is pretty big to run on the jointer and I don't have enough confidence in my No. 7 to joint edges for an 80 inche glueup.
Any ideas? Superglue...epoxy? Large forstner bit then glue in a plug? I'm open to suggestions.
Chuck