Hello,
Got an old Stanley 151 spokeshave off eBay a while back. The blade was pretty bad. Yesterday, I made a blade holder similar to what Paul Sellers uses. It worked OK but don't think it was made to work on a WorkSharp. I don't think the angle is quite right. I used it today and it seems to have a lot of tear out.
Think I'm going to get a flat piece of steel the same width and thickness, drill and tap some holes so I can mount the blade in a Veritas honing guide. Anyone ever try this or have a better approach?
TIA
Got an old Stanley 151 spokeshave off eBay a while back. The blade was pretty bad. Yesterday, I made a blade holder similar to what Paul Sellers uses. It worked OK but don't think it was made to work on a WorkSharp. I don't think the angle is quite right. I used it today and it seems to have a lot of tear out.
Think I'm going to get a flat piece of steel the same width and thickness, drill and tap some holes so I can mount the blade in a Veritas honing guide. Anyone ever try this or have a better approach?
TIA