After digging through the stuff in the garage, my quest to setup a small wood shop is starting to take shape. :wsmile: I thought I would share one of my projects with this group.
I discovered my router/ shaper station that I built about 15 years ago. It may look familiar as it was built from the Norm plans that my wife bought me one year for Christmas.
I've installed a PC 3hp 1/2" collet select speed router to the underside of the table. The wiring on the switch allows the router to start up and the vacuum to turn on at the same time. There is plenty of bit storage and under cabinet storage on the unit. the fences are setup to allow multi function in-feed and out-feed capabilities. I've used the machine a lot and continue to rely on it for spinning the really large panel bits safely.
I discovered my router/ shaper station that I built about 15 years ago. It may look familiar as it was built from the Norm plans that my wife bought me one year for Christmas.
I've installed a PC 3hp 1/2" collet select speed router to the underside of the table. The wiring on the switch allows the router to start up and the vacuum to turn on at the same time. There is plenty of bit storage and under cabinet storage on the unit. the fences are setup to allow multi function in-feed and out-feed capabilities. I've used the machine a lot and continue to rely on it for spinning the really large panel bits safely.