I have a Sear router table, with a plastic fence, and a stubby mitre guide. Not high tech (or high dollar), but usable. I am using Columbian router bits and some Sears bits.
Wednesday I was routing a 3/4" rabbet on all edges of two boards. Routing across the grain went OK, as long as I keep the wood firmly against the fence. When routing along the grain, I ended up with a thin piece of wood at the outside edge of the boards. This "leftover" was easiy snapped off.
What gives?
Wednesday I was routing a 3/4" rabbet on all edges of two boards. Routing across the grain went OK, as long as I keep the wood firmly against the fence. When routing along the grain, I ended up with a thin piece of wood at the outside edge of the boards. This "leftover" was easiy snapped off.
What gives?