This is an earring holder I designed for the Shaper Origin. I used a 1/16" up-cut spiral bit to cut out the large slots and the small slots for the earring posts. No need to remove the earring backs, just insert though the large opening and slip down into the small slot. I'm planning to add some thicker accent stiffeners to the sides.
NOTE: for some reason the Shaper Origin didn't interpret the design right and didn't cut all the earring post slots. I finished the uncut slots on the scroll saw.
NOTE: for some reason the Shaper Origin didn't interpret the design right and didn't cut all the earring post slots. I finished the uncut slots on the scroll saw.