I have been reading old post about finishing cherry. I don't have much experience except with your typical stain and brush on poly. I just finished up a cherry writing table and don't want to do the same thing. I have read that mixing ms, blo & poly is a good & easy choice from DaveO.
I could use some more details of the whole process though. Finish sand with 180, 220 or 320? I think this is a rub on formula, but do you sand in between coats? do you need to rub hard or just wipe it on? Typical drying time? etc...
What about the waterlox product, is that the same as DaveO's mix? Other suggestions are welcome also. Sorry to be such a newbie, but any details would help.
Thanks,
Keith
I could use some more details of the whole process though. Finish sand with 180, 220 or 320? I think this is a rub on formula, but do you sand in between coats? do you need to rub hard or just wipe it on? Typical drying time? etc...
What about the waterlox product, is that the same as DaveO's mix? Other suggestions are welcome also. Sorry to be such a newbie, but any details would help.
Thanks,
Keith