I've had some success cutting 2D and 3D images in brass with my small X-Carve and Stepcraft machines, making medallions for renaissance fairs. I started with Amana Spektra and ZrN-coated end mills, and finally got to very conservative cut speeds and widths that get the job done, and don't often break bits. But when it does happen, it is very discouraging, as the bits are in the $40 range.
Has anyone had any good experiences cutting non-ferrous materials with less expensive bits? It would be nice to find a source that would make it less traumatic when things go wrong.
Thanks.
Has anyone had any good experiences cutting non-ferrous materials with less expensive bits? It would be nice to find a source that would make it less traumatic when things go wrong.
Thanks.