Had some scrap and had watched a few videos on making bowls with out a lathe. So decided to give it a try. Did get a bit messy but would have probably been the same with a lathe. One bowl is 12 inches 2" ambrosia maple, just cleaned up and edge and glued together. One is Walnut 8" diameter. I had a 1" by piece so I cut in half and glued on on top of the other., was able to get a nice chevron pattern on the side The last is 7" diameter. Had a 2" thick hunk of cherry that had a lot of splits in it so I glued a 1" piece to the bottom for support, then after cut I add some epoxy to fill in and add strength. Finished with the same finish as the cutting boards i have made. It is a mix of mineral oil, bees wax and carnauba wax with the last coat buffed in.